DOD RTA Signal Processors Manuel du propriétaire

Naviguer en ligne ou télécharger Manuel du propriétaire pour Instruments de musique DOD RTA Signal Processors. DOD RTA Signal Processors Owner`s manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
The symbols shown above are internationally accepted symbols that warn of
potential hazards with electrical products. The lightning flash with arrowpoint in an
equilateral triangle means that there are dangerous voltages present within the
unit. The exclamation point in an equilateral triangle indicates that it is necessary
for the user to refer to the owner’s manual.
These symbols warn that there are no user serviceable parts inside the unit. Do
not open the unit. Do not attempt to service the unit yourself. Refer all servicing
to qualified personnel. Opening the chassis for any reason will void the manufac-
turer’s warranty. Do not get the unit wet. If liquid is spilled on the unit, shut it off
immediately and take it to a dealer for service. Disconnect the unit during storms
to prevent damage.
U.K. MAINS PLUG WARNING
A moulded mains plug that has been cut off from the cord is unsafe. Discard the
mains plug at a suitable disposal facility. NEVER UNDER ANY CIRCUMSTANCES
SHOULD YOU INSERT A DAMAGED OR CUT MAINS PLUG INTO A 13 AMP
POWER SOCKET. Do not use the mains plug without the fuse cover in place.
Replacement fuse covers can be obtained from your local retailer. Replacement
fuses are 13 amps and MUST be ASTA approved to BS1362.
SAFETY INSTRUCTIONS (EUROPEAN)
NOTICE FOR CUSTOMERS IF YOUR UNIT IS EQUIPPED WITH A POWER
CORD.
WARNING: THIS APPLIANCE MUST BE EARTHED.
The cores in the mains lead are colored in accordance with the following code:
GREEN and YELLOW - Earth BLUE - Neutral BROWN - Live
As colors of the cores in the mains lead of this appliance may not correspond with
the colored markings identifying the terminals in your plug, proceed as follows:
• The core which is colored green and yellow must be connected to the ter-
minal in the plug marked with the letter E, or with the earth symbol, or col-
ored green, or green and yellow.
• The core which is colored blue must be connected to the terminal marked
N or colored black.
• The core which is colored brown must be connected to the terminal marked
L or colored red.
CAUTION
ATTENTION:
RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE
RISK OF ELECTRIC SHOCK
DO NOT OPEN
1
R410 Manual 6/8/99 10:41 AM Page 1
Vue de la page 0
1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1 - U.K. MAINS PLUG WARNING

The symbols shown above are internationally accepted symbols that warn ofpotential hazards with electrical products. The lightning flash with arrowpo

Page 2 - IMPORTANT!

10SpecificationsFrequency Response: 10Hz - 30kHz, ±0.5dB.THD + Noise: < 0.04% @ 1kHz.Signal to Noise Ratio: Better than 97dB.Input Impedance: 20k

Page 3 - Front Panel

A Harman International CompanyDDDDOOOODDDD EEEELLLLEEEECCCCTTTTRRRROOOONNNNIIIICCCCSSSS CCCCOOOORRRRPPPPOOOORRRRAAAATTTTIIIIOOOONNNNOOOOWWWWNNNN

Page 4

DOD ELECTRONICS CORPORATION8760 SOUTH SANDY PARKWAYSANDY, UTAH 84107INTERNATIONAL DISTRIBUTION3 OVERLOOK DR. UNIT 4AMHERST, NEW HAMPSHIRE 03031U.S.A.F

Page 5 - Rear Panel

2These units comply with the European “EMC Directive” for emissions and suscept-ability.The power cord is terminated in a CEE7/7 plug (Continental Eur

Page 6 - INSTALLATION

INTRODUCTIONCongratulations, and thank you for your purchase of the 410Series II P.A./Monitor Processor. This monitor/speaker proces-sor is to be use

Page 7

45. Notch Filters - These two filters are very narrow bandwidthnotch filters that can provide 24dB of attenuation at the select-ed frequency. The x10

Page 8 - R410 Series II

Rear Panel1. Balanced Output -Accepts a female XLR plug (see sectionon installation for wiring). Maximum balanced output level is21dBu. Output im

Page 9 - DOD Warranty

6INSTALLATIONInstall the 410 in a rack with the provided rack screws. Routethe AC power cord to a convenient power outlet away fromaudio lines. Conn

Page 10 - Specifications

ate the second oscillating frequency using the second notch fil-ter.C. Limiting sets the maximum allowable output level as set bythe threshold contro

Page 11

8House P.A. application:Permanent installation multi-room application:Maintenance and ServiceOther than keeping the unit clean and occasionally checki

Page 12 - MANUFACTURED IN THE U.S.A

Should a problem arise with the product, please contact yourauthorized DOD Electronics dealer for return/repair procedures.DOD WarrantyThe warranty re

Commentaires sur ces manuels

Pas de commentaire