DOD SR400D Spécifications télécharger pdf (Page 155)

147

 39. Move the high/low selector switch (near the remote

cable hookup point) to the "HIGH" position.

 40. Disconnect

inch formulation line from the "T" on

the spray boom and place into a "pesticide only"

bucket. Use a suitable collection container for

actual pesticide measurement.

 41. Move the function select switch on the remote

control to the "#2" position.

 42. Place the mode switch on the remote control in the

"SPRAY" position.

 43. Place the output switch on the remote control in

the "ON" position (fluid will begin to flow).

 44. Adjust the flow rate knob on the remote control to

the desired level.

 45. Have the timing person signal the beginning and

the end of the one-minute collection period.

 46. Collect sample and compare actual output with

output indicated by remote control digital readout.

 47. If the sample is not within 20% of the volume given

by the remote control digital readout, then contact

the manufacturer, NDVECC or a NEPMU.

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 243 244

Pas de commentaire

DOD SR400D Spécifications Page 155