DOD SR400D Spécifications télécharger pdf (Page 180)

172

 3. Check the engine oil level using the dipstick on the

left side of the engine below the fuel filter. Use

30W oil for the engine.

 4. Check the blower oil level. The plug is located on

the side closest to the drain plug. Fill through the

breather plug at the top until it reaches the bottom

of the overflow hole. (Do not remove the upper

plug nearest the breather plug.) Use 40W non-

detergent oil for the blower.

 5. Periodically grease the two fittings, located behind

the blower above the drive shaft from the engine,

with chassis grease.

 6. Check the battery water level. Add water to the

proper level.

 7. Ensure that the sprayer battery cables are clean

and tightly connected.

 8. Check the flushing solution level and fill the

container as needed. This tank is located behind

the constant volume control panel (plastic tank).

 9. Open the gasoline control valve located under the

center of the gasoline tank.

 10. Close the choke located under the engine air filter

by pulling out the ring. (Omit this step if the engine

is already warm.)

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 243 244

Pas de commentaire

DOD SR400D Spécifications Page 180